Feeder-Straightener Series TAP

 
The feeder-straighteners of series "TAP" do have a straightening head with piloting function. The piloting is done by lifting the upper part of the straightening head parallely. These feeder-straighteners are suitable for use in combination with press dies with piloting pins.

Feeder-straighteners of series "TAP" as a standard are available with

• Roll Diameter of straightening rolls 80 mm
• 2 entry pinch rolls, 7 straightening rolls and 2 exit pinch rolls.
• Single adjustment of upper straightening rolls with indication of immersion depth
• Manual adjustment of upper entry- and exit pinch rolls
• Measuring gauges for indication of immersion depth
• Material guidance installation at entry side
• Maximum feeding speed 35 meter / minute
• For yield strength aprox 420 N/mm²
• Minimum material thickness aprox 0,6 mm
• Maximum material thickness 3,5 – 1,0 mm, depending on material width, without support rolls 
• Rolls hardened and grinded, 58 + 1 HRC
• Roughness of rolls 0,2 micron
• Maximum material widths of 200 mm, 300 mm, 400 mm, 500 mm, 650 mm, 800 mm
  and 1.000 mm
• Passline height 1.050 mm without height adjustment

• Standard positioning control
• Maintenance-free AC-Servomotor
• Machine stand with press mounting plate

 
Optionally for these feeder-straighteners there are a lot of accessories available, for example:

• Electronic cam
• Measuring wheel for slip detection
• Positioning control as version with Siemens electronics
• Hard chrome plated rolls
• Maximum feeding speed 50 meter / minute
• Manual height adjustment + - 100 mm
• Motorised height adjustment + - 100 mm
• Pneumatically operated material entrance table with 2 moving functions
• Hydraulically operated material entrance table with 2, 4 or 6 moving functions

Regarding electric control we can offer our feeder straighteners with low priced standard control, upon request we also can offer them with Siemens-control. Here we follow to your preferences. Our feeder-straighteners also are very well usable for being integrated into existing coil feeding lines of any brand. Let us have your inquiry for your demand for substitution of feeder-straightener. We will be happy to provide you with an interesting offer. 

Our feeder-straighteners are produced by our partner CAMU at Bressanvido / Italy. CAMU has more than 30 years of experience regarding production of coil feeding lines and all types of machines being part of such lines. Within Germany CAMU exclusively is represented by Seidel Handlingsysteme GmbH.
We will take care for you from first consulting, also at site, via submission of suitable offer and order processing up to the corresponding service.    

At the area on the right side you will find a list of standard feeder straighteners out of the series described above, including the technical data of the single models. If you will not find there the suitable model or if you will have wishes deviating from the listed specifications, please do contact us.

Please inform us about your requirement regarding the feeder-straightener searched by you. Basing on the base machines listed on this page as well as optional accessories we will configurate your individual feeder-straightener. We are prepared to check and realise any further adaptation of the feeder-straightener which may be needed.

Please contact us by phone or email.

Tel.: 0049 2156 419193
Fax: 0049 2156 4979325
eMail: info@seidel-handlingsysteme.de